I have the Baby Loop with the 2.2 firmware connected to a Yaesu FTDX3000 and use the com port to connect the ATU 2.0 to my computer. I use WRJT-X to do WSPR and have band hopping from the bands between 10m and 40m.
Everything works great!
However.... Every so often, after the software changes band and the ATU 2.0 catches the frequency change and retunes to the new frequency, the SWR goes above the 3.5 level and the ATU 2.0 displays a SWR error.
If I was sitting in front of the radio, this wouldn't be a problem. I could acknowledge the error and retune and be good to go. However, I like to run this 24x7 and may not be near.
What I would like to see is timeout for the error so when the software changes frequency again, the ATU will retune. Otherwise, the software is changing bands, but the antenna / ATU isn't and creates a problem.
Thank you for looking into this.