The controller would not upgrade to the new firmware and now the screen says Board 1.06.0445 Initialize USB and continues to stay on the screen . nothing seems to work to get back to the begenning of the start up. Cannot seem to get much support from where I purchased it Erad like 0 ! except go back here to the factory . So here I am anyone got any ideas ? Any help I can that can be provided would be greatly appreciated , as its a non working antenna to this point .
6 giorni fa
Anyone suffer from poor tune on 20m when the Midi loop gets wet? When I build this one I noticed that the Gamma match tubing had a badly seated cap, when I removed it to inspect a few drops of water came out of the tube. Am going to take the loop down today and inspect this again as its been quite wet recently but am interested to know if this is a known issue. This is a used loop and as far as I know it was stored indoors prior to my assembly and when I did the build, the loop was only outdoors for about 2 days before it went on the mast. Was rather surprised to see the water and trying to tun last night when raining, 20m was nothing below 2.1, today now its dry kinda back to normal at 1.6 ish. Real concerned that water is getting into the co-ax section and thats bound to be bad news. 73s Pete